Access the full text.
Sign up today, get DeepDyve free for 14 days.
Loading next page...
/lp/de-gruyter/determining-the-total-dispersion-zone-for-micrometer-s-m-measuring-oy6BbaLaJF
References
References for this paper are not available at this time. We will be adding them shortly, thank you for your patience.
- Publisher
- de Gruyter
- Copyright
- Copyright © 2011 by the
- ISSN
- 1336-1589
- eISSN
- 1338-0532
- DOI
- 10.2478/v10186-010-0038-7
- Publisher site
- See Article on Publisher Site
Abstract
Determining the Total Dispersion Zone for Micrometer S M Measuring Equipment The aim of the total dispersion zone for measuring equipment S M is to define if three workers A, B, C can achieve the same values of measurement using the same measuring equipment. Before estimating the total dispersion zone for measuring equipment S M . the calibration of the micrometer was carried out. The values were obtained by measuring the width of clip anchor. It is necessary to calculate the average values X A , X B , X C and to calculate standard deviations S ΔA , S ΔB , S ΔC for three workers. Finally, the total dispersion zone SM will be calculated and the results will be interpreted.
Journal
Research Papers Faculty of Materials Science and Technology Slovak University of Technology – de Gruyter
Published: Jan 1, 2011